User's Manual

WP201 Access Point: User Manual
2.6 Pole Mounting the WP201
Tools Needed for this Procedure
l Drill
l 8mm drill bit
l Hammer
l Screwdriver
l Pliers
l Box-end wrenches
Procedure
Note: For illustration purposes, the images in this section DO NOT have the antennas or cables
attached to the WP201.
1. Verify all antennas are attached to their correct ports and the Ethernet cable is connected
between the PoE Injector and the WP201.
2. Using the enclosed Packaged Ground Screw, attach the loop end of one of the supplied
Green Ground Cables to the ground point on the Back of the WP201 (on page 14).
Figure 23: Attached Ground Cable
3. Place the lock and flat washers on the four hex cap screws.
LUM0073AA Rev Aug-2015 Page 29 of 38
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.