User's Manual

2. WP201 Installation and Setup
8. Tighten the nut and flat washers to secure the bracket to the mounting surface.
Figure 22: Tighten the nut and flat washers to secure the bracket.
9. Attach the wire end of the Green Ground Cable to a grounding rod (the loop end was
attached to the WP201 in a previous step).
Page 28 of 38 LUM0073AA Rev Aug-2015
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.