User's Manual

2. WP201 Installation and Setup
4. Verify all antennas are attached to their correct ports and the Ethernet cable is connected
between the PoE Injector and the WP201.
5. Using the enclosed Packaged Ground Screw, attach the loop end of one of the supplied
Green Ground Cables to the ground point on the Back of the WP201 (on page 14).
Figure 20: Attached Ground Cable
6. Place the lock and flat washers on the four hex cap screws.
Page 26 of 38 LUM0073AA Rev Aug-2015
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.