User's Manual

WP201 Access Point: User Manual
2.5 Wall Mounting the WP201
Tools Needed for this Procedure
l Drill
l 8mm drill bit
l Hammer
l Screwdriver
l Pliers
l Box-end wrenches
Procedure
Note: For illustration purposes, the images in this section DO NOT have the antennas or cables
attached to the WP201.
1. Using the Mounting Bracket as a template, mark the locations of the mounting holes on
the wall.
Figure 18: Marked locations of the mounting holes.
2. Drill a 37mm deep, 8mm diameter hole in each of the markings on the wall.
3. Using the bolts in the Mounting Kit Package, hammer the bolts into the openings.
Figure 19: Hammer the bolts into the drilled openings.
LUM0073AA Rev Aug-2015 Page 25 of 38
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.