User's Manual

Introduction

This document describes the applicability of user operation of FreeWave’s W5800-01 RF module to keep

compliance with regulatory requirements.

Host System

This module is intended to be used only with FreeWave’s system products. FreeWave’s system must supply

regulated voltage to the module.

Antenna Usage

This module can only be used with the type of antennas approved to be used with FreeWave’s system. The

use of a higher gain or a different type of antenna than the antennas approved with FreeWave’s FCC

submission requires new FCC approval.

The antennas used with this module may only be collocated and placed as identified on the FCC grant.

Certificated Antennas

Model

Type

5150~5.850MHz

Y5815

Yagi

15 dBi

ZDAQJ5800-12

Omni

12 dBi

P250-5.8

Panel

14.4 dBi

ZDAGP5800-24-12

Dish

24 dBi

98618UNXX000

Dipole

7 dBi

Module Label

The host system containing this module must either:

 Make the module label visible so the FCC ID is visible in the installation

 Label the end system product with the FCC ID and IC ID of the module

Professional Installation Instructions

1. Installation personnel

This product is designed for specific applications and needs to be installed by qualified personnel who

have RF and related rule knowledge. The general user shall not attempt to install or change settings.

2. Installation location

The product shall be installed at a location where the radiating antenna can be kept 26 cm from nearby

persons in normal operation condition to meet regulatory RF exposure requirement.