User Manual

Page 4 of 40 LUM0075AA Rev May-2016
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.
No part of this manual may be reproduced or transmitted in any form or by any means, electronic or mechanical,
or for any purpose without the express written permission of FreeWave Technologies, Inc. FreeWave reserves
the right to make changes to this manual without notice. FreeWave assumes no responsibility or liability for the
use of this manual or the infringement of any copyright or other proprietary right.
UL Power Source
Input power shall be derived from a certified, Class 2:
l single power source or
l an limited power source (LPS) in accordance with IEC/EN 60950-1.
l Input voltage for the ZumLink Z9-C or Z9-T is +3 to +5VDC (±10%).
ZumLink Z9-C or Z9-T Product Safety
Standards and Editions
l HazLoc Standards
l ANSI/ISA 12.12.01-2013
l Ordinary Location Standards
l UL 60950, 2nd Edition
l CAN/CSA-C22.2 No. 60950, 2nd Edition
l IEC 60950, 2nd Edition
l EN 60950, 2nd Edition
Schedule of Limitations
l Antenna connection is internal wiring only.
l The Ex Components shall only be used in an area of not more than pollution degree 2, as defined in
IEC/EN60664-1.
l The Ex Components shall be installed in an enclosure with tool removable door or cover that provides a
degree of protection not less than IP 54 in accordance with IEC/EN60679-15.
l Transient protection shall be provided that is set at a level not exceeding 140 % of the peak rated voltage
value at the supply terminals to the equipment.
l All connectors (J1 to J4) do not have mating connectors with the devices.
l The securement of these connectors must be evaluated during end-product investigation.
l Temperature test was conducted at a rated supply voltage and the maximum surface temperature of 61°C
was recorded at 60°C ambient temperature.