User Manual

ZumLink Z9-C or Z9-T
system - ZumLink Settings and Descriptions
Page CLI Command Description
[Page=system] system.serialMode= This setting designates the serial port mode as either passthrough or packetized.
l In passthough mode, the serial port is used for data or configuration but not at the
same time.
l In packetized mode, both data and configuration is passed over the serial port
simultaneously within a predefined packet.
Note: The default value is Packetized.
[Page=system] system.pages This command lists all of the pages in the ZumLink Z9-C or Z9-T.
systemInfo
systemInfo - ZumLink Z9-C or Z9-T Settings and Descriptions
Page CLI Command Description
[Page=systemInfo] systemInfo.deviceConfiguration=
Note: The default value is A.
[Page=systemInfo] systemInfo.deviceModel=
[Page=systemInfo] systemInfo.deviceSerialNumber= This setting identifies the serial number of the ZumLink Z9-C or Z9-T.
[Page=systemInfo] systemInfo.FirmwareVersion= This setting identifies the firmware version of the ZumLink Z9-C or Z9-
T.
[Page=systemInfo] systemInfo.hopTableVersion= This setting identifies the Hop Table Version.
LUM0075AA Rev May-2016 Page 36 of 40
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by FreeWave. This document cannot be reproduced
in whole or in part by any means without written permission from FreeWave Technologies, Inc.