User Manual

5. ZumLink Z9-C or Z9-T Settings and Descriptions
Page 35 of 40 LUM0075AA Rev May-2016
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by FreeWave. This document cannot be reproduced
in whole or in part by any means without written permission from FreeWave Technologies, Inc.
serialPortConfig - ZumLink Settings and Descriptions
Page CLI Command Description
[Page=serialPortConfig] serialPortConfig.stopbits= This setting defines the number of stop bits of the serial port.
Note: The default value is 1.
[Page=serialPortConfig] serialPortConfig.flowControl= This setting is used to set the flow control of the serial port..
Note: The default value is Hardware.
[Page=serialPortConfig] serialPortConfig.passthruLatencyMode=
Note: The default value is Auto.
[Page=serialPortConfig] serialPortConfig.passthruLatencyTimer=
Note: The default value is 16.
system
system - ZumLink Settings and Descriptions
Page CLI Command Description
[Page=system] system.exit This setting is used to exit the configuration menu and into normal operation for
transmitting and receiving data.