User Manual

5. ZumLink Z9-C or Z9-T Settings and Descriptions
Page 33 of 40 LUM0075AA Rev May-2016
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by FreeWave. This document cannot be reproduced
in whole or in part by any means without written permission from FreeWave Technologies, Inc.
radioSettings - ZumLink Settings and Descriptions
Page CLI Command Description
[Page=radioSettings] radioSettings.txPower= l This setting defines the RF output transmit power for the radio.
l A higher power can be used to increase link margin.
l Use a lower transmit power to reduce interference when multiple
radio networks are in close proximity.
l Enter 10 to 30
l At 250K rfDataRate, if the number of frequencies in the hop table is
>= to 50 after the masks are applied, txPower is limited to 30dB.
l If the number of frequencies are >= 30, but < 50, txPower is set to
.25 W (24dbm) ONLY if the current setting for txPower is >= 24dB.
Note: The default value is 26.
radioStatus
radioStatus - ZumLink Settings and Descriptions
Page CLI Command Description
[Page=radioStatus] radioStatus.curRssi=- This setting designates the WHAT.
Enter any number between what and what.
Note: The default value is 89.