User Manual

ZumLink Z9-C or Z9-T
radioSettings - ZumLink Settings and Descriptions
Page CLI Command Description
[Page=radioSettings] radioSettings.rfDataRate=
Note: This is a ZumLink Golden Setting.
This setting defines the RF link data rate speed in bits per second.
l A higher RF link data rate provides more throughput at the expense
of link distance or fade margin.
l When changing from lower data rates to higher ones (e.g., RATE_
115.2K to RATE_1M), the radioFrequency may be set back to
915.000 MHz if the signal would have been out of band.
l The communication range is dependent on the rfDataRate setting.
l The min value increases and the max value decreases as the
rfDataRate increases.
l The increase of channel bandwidth affects these ranges.
Important!: The Gateway and Endpoint radios MUST use the
same value for this setting.
The options are:
l RATE_4M
l RATE_1M
l RATE_500K
l RATE_250K
l RATE_115.2K
Note: The default value is RATE_1M.
LUM0075AA Rev May-2016 Page 32 of 40
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by FreeWave. This document cannot be reproduced
in whole or in part by any means without written permission from FreeWave Technologies, Inc.