User Manual

5. ZumLink Z9-C or Z9-T Settings and Descriptions
Page 31 of 40 LUM0075AA Rev May-2016
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by FreeWave. This document cannot be reproduced
in whole or in part by any means without written permission from FreeWave Technologies, Inc.
radioSettings - ZumLink Settings and Descriptions
Page CLI Command Description
[Page=radioSettings] radioSettings.radioHoppingMode=
Note: This is a ZumLink Golden Setting.
The radioHoppingMode parameter is used to enable or disable
frequency hopping.
Important!: The Gateway and Endpoint radios MUST use the
same value for this setting.
l For rfDataRate values >= 500kbps, the choice of hopping mode
should be selected based on network frequency planning and
channel conditions.
l For rfDataRate values < 500kbs, radioHoppingMode is forced On.
The options are:
l Hopping_Off
l Hopping_On
Example: radioSettings.radioHoppingMode=Hopping_On.
Note: The default value is Hopping_Off.
[Page=radioSettings] radioSettings.radioMode= This setting designates the device as a Gateway or Endpoint unit.
l Each network MUST have only ONE Gateway unit.
l The remaining units MUST be configured as Endpoints.
l The Gateway device will always have a nodeId of value 1.
l A Gateway is only needed when Frequency Hopping is enabled.
l A Gateway is NOT required when operating with a single channel.
Note: The default value is Endpoint.