User Manual

ZumLink Z9-C or Z9-T
radioSettings - ZumLink Settings and Descriptions
Page CLI Command Description
[Page=radioSettings] radioSettings.radioFrequency=
Note: This is a ZumLink Golden Setting.
This setting designates the Operating Center Frequency in MHz.
l The radioFrequency parameter ONLY takes effect when
radioHoppingMode=Hopping_Off.
l All radios in a network must have the same frequency.
l If the radioFrequency parameter is set too close to the band edge
for the current rfDataRate, the radio module will reject the setting.
Read back this value after setting it to determine if it was
accepted by the radio module.
Valid boundaries are:
l 4M data rate: 904.5504 - 925.7472 MHz
l 1M data rate: 903.0528 - 927.0144 MHz
l 500K data rate: 902.7072 - 927.3600 MHz
l 250K data rate: 902.5344 - 927.4176 MHz
l 115.2K data rate: 902.4768 - 927.5904 MHz
Note: The default value is 915.0000.
LUM0075AA Rev May-2016 Page 30 of 40
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by FreeWave. This document cannot be reproduced
in whole or in part by any means without written permission from FreeWave Technologies, Inc.