User Manual

5. ZumLink Z9-C or Z9-T Settings and Descriptions
Page 27 of 40 LUM0075AA Rev May-2016
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by FreeWave. This document cannot be reproduced
in whole or in part by any means without written permission from FreeWave Technologies, Inc.
radioSettings - ZumLink Settings and Descriptions
Page CLI Command Description
[Page=radioSettings] radioSettings.lnaBypass= The lnaBypass setting controls enabling and disabling the Low Noise
Amplifier (LNA) which can boost the receive signal by 10dB.
l The options are 0 (zero) and 1.
l When the lnaBypass=1, the LNA of the radio module is
bypassed.
l If lnaBypass=0, the LNA is enabled.
l If lnaBypass=<anything but 0> it is set to 1.
It can be useful to bypass the LNA if there is a presence of
strong signals in band and packet reception is not good.
Note: The default value is 0 (zero).
[Page=radioSettings] radioSettings.maxLinkDistanceinMiles= The maxLinkDistanceinMiles setting controls the maximum one-way
distance (in miles) between any node in the network.
Important!: All nodes in the network that communicate with each
other should use the same distance value.
l The minimum value is 0 (zero) miles.
l The maximum value is 120 miles.
Note: The default value is 20 miles.