User Manual

ZumLink Z9-C or Z9-T
radioSettings - ZumLink Settings and Descriptions
Page CLI Command Description
[Page=radioSettings] radioSettings.frequencyMasks=
(continued)
l Errors occur when masking reduces the number of frequencies
below regulatory minimums.
l For channel sizes < 500kHz, the radio must frequency hop.
l This does NOT apply for channel sizes greater than 500 kHz
which can operate single channel or frequency hopping.
l If the radioSettings.rfDataRate=RATE_250K:
l If the number of hopping channels is >= 50, the maximum
txPower is 30dBm.
l If the number of channels is 25 to 49, the maximum txPower is
24dBm.
l If the number of hopping channels contained in the hop table is <
25, all masking is removed and all of the channels contained in
the hop table are re-enabled and txPower is NOT changed.
l If the radioSettings.rfDataRate=RATE_115.2K:
l If the number of hopping channels is >= 50, the maximum
txPower is 30dBm.
l If the number of hopping channels contained in the hop table is <
50, all masking is removed and all of the channels contained in
the hop table are re-enabled and txPower is NOT changed.
Notes
l Both Gateway and Endpoint radios MUST use the same value for
the frequencyMasks setting.
l If the frequencyMasks comes back empty see
frequencyMasksErrors for any errors.
l Use frequencyMasks=1 to clear the frequency Masks.
John asks if there's another way to do this clearing?
Note: The default value is Blank.
LUM0075AA Rev May-2016 Page 26 of 40
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by FreeWave. This document cannot be reproduced
in whole or in part by any means without written permission from FreeWave Technologies, Inc.