User Manual

ZumLink Z9-C or Z9-T
radioSettings - ZumLink Settings and Descriptions
Page CLI Command Description
[Page=radioSettings] radioSettings.frequencyMasks= Frequency Masks are used to mask off frequencies or a set of
frequencies in a hop table.
Single Channel Format
l frequencyMasks=xxx.yyyy,xxx.yyyy,xxx.yyyy.
Example: frequencyMasks=903.0000,908.0000,925.0000.
Range of Channels Format
l frequencyMasks=xxx.yyyy-xxx.yyyy,xxx.yyyy.
Example: frequencyMasks=902.1000-905.1000,920.1000-
927.9000
Combination of Channels Format
l frequencyMasks=902.1000-905.1000,920.1000-
927.9000,915.0200
Where:
l xxx is a value between 902-927.
l yyyy is a value between .0000-.9999.
Note: Least significant digits are not required.
Example: .9, .09, .009 are valid entries.
Important!: Frequency mask entries MUST BE less than 128
bytes.
A comma MUST separate the values - NOT a comma and a
space.
LUM0075AA Rev May-2016 Page 24 of 40
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by FreeWave. This document cannot be reproduced
in whole or in part by any means without written permission from FreeWave Technologies, Inc.