User Manual

ZumLink Z9-C or Z9-T
radioSettings
radioSettings - ZumLink Settings and Descriptions
Page CLI Command Description
[Page=radioSettings] radioSettings.beaconInterval=
Note: This setting is only available when Frequency Hopping is
enabled.
The beaconInterval controls how often a Gateway radio sends out a
beacon packet and changes to the next radio frequency in the hopping
pattern.
l A longer beaconInterval gives the system better throughput in
channel environments where interference is minimal.
l Throughput can be improved in some situations with shorter beacon
intervals.
Important!: The Endpoint radios will obtain this value from a
Gateway with the same networkId.
Editing this value when the radioMode is set to Endpoint will
return an OK; HOWEVER, the value will become what the
Gateway is set to as soon as it processes a received beacon.
The options are:
l TWENTY_FIVE_MS
l FIFTY_MS
l ONE_HUNDRED_MS
l TWO_HUNDRED_MS
l FOUR_HUNDRED_MS
Example: radioSettings.beaconInterval=FIFTY_MS.
Note: The default value is FOUR_HUNDRED_MS.
LUM0075AA Rev May-2016 Page 22 of 40
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by FreeWave. This document cannot be reproduced
in whole or in part by any means without written permission from FreeWave Technologies, Inc.