User Manual
Table Of Contents
ZumLink Z9-C or Z9-T
diagPortConfig
diagPortConfig - ZumLink Settings and Descriptions
Page CLI Command Description
[Page=diagPortConfig] diagPortConfig.cliBaudRate= This setting sets the baud rate for the diagnostic port.
The options are:
l What are the options here?
l
l
l
Note: The default value is 115200.
[Page=diagPortConfig] diagPortConfig.databits= This setting defines the byte length for the diagnostic port.
The options are:
l 7 bits
l 8 bits
Note: The default value is 8.
[Page=diagPortConfig] diagPortConfig.diagBaudRate=
Note: The default value is 115200.
LUM0075AA Rev May-2016 Page 20 of 40
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by FreeWave. This document cannot be reproduced
in whole or in part by any means without written permission from FreeWave Technologies, Inc.