User Manual

ZumLink Z9-C or Z9-T: User Manual
Figure 7: ZumLink radioSettings
14. Set the radioSettings.txPower between 10 and 30.
Example: txPower=30 or radioSettings.txPower=30.
15. Select one radio and set the radioSettings.radioMode=Gateway.
16. Set the other radios in the network with a radioSettings.radioMode=Endpoint.
17. Set the radioSettings.networkId to be the same on all radios in the network.
18. On each Endpoint, set the radioSettings.nodeId to a unique number (between 2 and
65533) in the network.
Important!: The Gateway radioSettings.nodeId defaults to 1 and CANNOT be changed.
19. Type Save (for the settings to remain after a power cycle) and press <Enter>.
20. Type exit and press <Enter> to exit the FreeWave Shell.
Type help to view additional information about the ZumLink settings.
LUM0075AA Rev May-2016 Page 13 of 40
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.