User Manual

ZumLink Z9-C or Z9-T: User Manual
Figure 3: Serial menu > Setup Port
The Tera Term: Serial Port Setup dialog box opens.
Note: The image shows the default ZumLink settings.
Figure 4: Tera Term: Serial Port Setup dialog box with default settings
7. Verify, and change if required, the Tera Term serial port settings (except the Port setting)
of the connected ZumLink so the settings are the same as the defaults shown in the image.
Example: If the Baud Rate is 9600, click the list box arrow and select 115200.
8. Click OK to save the changes and close the dialog box.
9. On the ZumLink, pull the Pin 2-Interrupt line Low to activate the FreeWave Shell and
disrupt data flow.
10. Return Pin 2-Interrupt to High.
LUM0075AA Rev May-2016 Page 11 of 40
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.