User Manual

2. ZumLink Z9-C or Z9-T CLI Configuration
Page 10 of 40 LUM0075AA Rev May-2016
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.
Figure 1: File menu > New Connection
The Tera Term New Connection dialog box opens.
4. Click the Port list box arrow and select the COM port the ZumLink device is connected to.
Figure 2: Select the ZumLink COM port
5. Click OK to save the changes and close the dialog box.
The Tera Term window shows the connected COM port and Baud rate in the title bar of the
window.
6. In the Tera Term window, click the Setup menu and select Serial Port.