User Manual

5. ZumLink Z9-C or Z9-T Settings and Descriptions
Page 34 of 40 LUM0075AA Rev May-2016
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by FreeWave. This document cannot be reproduced
in whole or in part by any means without written permission from FreeWave Technologies, Inc.
serialPortConfig
serialPortConfig - ZumLink Settings and Descriptions
Page CLI Command Description
[Page=serialPortConfig] serialPortConfig.cliBaudRate= This setting designates the WHAT.
Enter any number between what and what.
The default value is 89.
Caution: reset=now MUST be manually entered into the
command line after the baudRate parameter is defined.
Note: The default value is 115200.
[Page=serialPortConfig] serialPortConfig.packetizedBaudRate= This setting defines the data rate of the serial port when operating in
packetized mode.
Note: The default value is 3000000.
[Page=serialPortConfig] serialPortConfig.passthruBaudRate= This setting defines the data rate of the serial port when operating in
pass through mode.
Note: The default value is 115200.
[Page=serialPortConfig] serialPortConfig.databits= This setting defines the number of data bits per byte for the serial
port.
Note: The default value is 8.
[Page=serialPortConfig] serialPortConfig.parity= This setting defines the parity of the serial port.
Note: The default value is None.