User Manual

5. ZumLink Z9-C or Z9-T Settings and Descriptions
Page 26 of 40 LUM0075AA Rev May-2016
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by FreeWave. This document cannot be reproduced
in whole or in part by any means without written permission from FreeWave Technologies, Inc.
radioSettings - ZumLink Settings and Descriptions
Page CLI Command Description
Example: A single entry such as 904.0 masks off any
frequencies using 904.0 as a center frequency along with any
bandwidth on each side of the center frequency as a function of
rfDataRate.
A frequency range such as 904.0-906.9999 masks off any
frequencies in the range of 904.0 minus the bandwidth associated
with the data rate, through 906.9999 plus the bandwidth
associated with the data rate.
l Errors occur when masking reduces the number of frequencies
below regulatory minimums.
l For channel sizes < 500kHz, the radio must frequency hop.
l If the number of channels is >= 50, the maximum transmit output
power is 30dBm.
l If the number of channels is < 50, the transmit output power is
24dBm.
l This does NOT apply for channel sizes greater than 500 kHz
which can operate single channel or frequency hopping.
Notes
l Both Gateway and Endpoint radios MUST use the same value for
the frequencyMasks setting.
l If the frequencyMasks comes back empty see
frequencyMasksErrors for any errors.
l Use frequencyMasks=1 to clear the frequency Masks.
John asks if there's another way to do this clearing?
Note: The default value is Blank.