Reference Manual
Table Of Contents
- Preface
- 1. Overview
- Untitled
- 2. Equipment
- 3. Installation
- 4. Basic Radio Programming and Setup
- 4.1. Define the Network Type and the Radio's Role in that Network
- 4.2. Establish Communication with Instrumentation and Computers
- 4.3. Establishing Communication with Other Radios in the Network
- 4.4. Set the Data Transmission Characteristics
- 4.5. Set Radio Passwords
- 4.6. Set the Hop Table Size in the Terminal Interface
- 4.7. Set the Radio to a Single Channel in a Terminal Emulator
- 4.8. Set the Radio to Hop Channels
- 4.9. Edit Frequencies for Multiple Channels
- 5. Configure Point-to-MultiPoint Networks
- 5.1. Point to MultiPoint Network Characteristics
- 5.2. Point-to-MultiPoint Network Quick Start (Terminal Interface)
- 5.3. Overlapping MultiPoint Networks
- 5.4. Establishing Communication with Other Radios in a MultiPoint Network
- 5.5. Routing Communication Through the Network
- 5.6. Setting Other MultiPoint Parameters
- 5.7. Reading Diagnostics in Tool Suite
- 6. Configure Point-to-Point Networks
- 7. View Radio Statistics
- 8. Release Notes
- 9. Additional Radio Information
- Appendix A: Technical Specifications
- Appendix B: RF Board Pin-Out
- Appendix C: RS232 Pin Assignments - DB9
- Appendix D: LRS455 Frequency Table
- Appendix E: Factory Default Settings
- Appendix F: Point-to-MultiPoint Operation LEDs
- Appendix G: Point-to-Point Operation LEDs
- Appendix H: FreeWave Legal Information
- Blank Page
- Blank Page
7. View Radio Statistics
When a radio is read, the system shows data transmission statistics the radio has gathered during
the most recent session. This information is valuable to know the signal strength and noise levels
of the link. Statistics are gathered during each data link and are reset when the next link begins.
Note: More data transmission characteristics are available in the Network Diagnostics application.
For information about running network diagnostics, see the Tool Suite User Manual.
l View Statistics in Tool Suite (on page 83)
l View the Radio Transmission Characteristics in the Terminal Interface (on page 83)
l Antenna Fwd (on page 83)
l Antenna Reflected Power (on page 83)
l Antenna Rev (on page 83)
l Master-Slave Distance (on page 84)
l Noise Level (on page 84)
l Number of Disconnects (on page 84)
l Radio Temperature (on page 85)
l Rate % (on page 85)
l Signal Level (on page 85)
LUM0020CD Rev June-2020 Page 82 of 112 Copyright © 2019FreeWave
This document is subject to change without notice. This document is the property of FreeWave Technologies, Inc.
and contains proprietary information owned by FreeWave. This document cannot be reproduced in whole or in
part by any means without written permission from FreeWave Technologies, Inc.
LRS455A-C, LRS455A-CE, LRS455-T
User-Reference Manual