Reference Manual
Table Of Contents
- Preface
- 1. Overview
- Untitled
- 2. Equipment
- 3. Installation
- 4. Basic Radio Programming and Setup
- 4.1. Define the Network Type and the Radio's Role in that Network
- 4.2. Establish Communication with Instrumentation and Computers
- 4.3. Establishing Communication with Other Radios in the Network
- 4.4. Set the Data Transmission Characteristics
- 4.5. Set Radio Passwords
- 4.6. Set the Hop Table Size in the Terminal Interface
- 4.7. Set the Radio to a Single Channel in a Terminal Emulator
- 4.8. Set the Radio to Hop Channels
- 4.9. Edit Frequencies for Multiple Channels
- 5. Configure Point-to-MultiPoint Networks
- 5.1. Point to MultiPoint Network Characteristics
- 5.2. Point-to-MultiPoint Network Quick Start (Terminal Interface)
- 5.3. Overlapping MultiPoint Networks
- 5.4. Establishing Communication with Other Radios in a MultiPoint Network
- 5.5. Routing Communication Through the Network
- 5.6. Setting Other MultiPoint Parameters
- 5.7. Reading Diagnostics in Tool Suite
- 6. Configure Point-to-Point Networks
- 7. View Radio Statistics
- 8. Release Notes
- 9. Additional Radio Information
- Appendix A: Technical Specifications
- Appendix B: RF Board Pin-Out
- Appendix C: RS232 Pin Assignments - DB9
- Appendix D: LRS455 Frequency Table
- Appendix E: Factory Default Settings
- Appendix F: Point-to-MultiPoint Operation LEDs
- Appendix G: Point-to-Point Operation LEDs
- Appendix H: FreeWave Legal Information
- Blank Page
- Blank Page
6. Configure Point-to-Point Networks
LUM0020CD Rev June-2020 Page 78 of 112 Copyright © 2019FreeWave
This document is subject to change without notice. This document is the property of FreeWave Technologies, Inc.
and contains proprietary information owned by FreeWave. This document cannot be reproduced in whole or in
part by any means without written permission from FreeWave Technologies, Inc.
14. Enter the Slave serial number in the Master’s Call Book.
15. Enter the Master’s Serial number in the Slave’s Call Book or
disable the Slave Security (on page 47) parameter in the Slave.
Note: For more information about setting up the Call Book see Using in Point-to-Point
Networks.
16. On the Main Menu, type 3 and press <Enter>.
17. Set these parameters so they are identical on all radios in the network:
a. Max Packet Size and Min Packet Size (on page 40)
b. RF Data Rate (on page 45)
c. Rx Frequency (on page 46)
d. Tx Frequency (on page 50)
Note: The Tx Frequency and Rx Frequency options, or Frequency Key, are located in the F
submenu after you press 0 to access the Frequency Key menu in Main menu 3.
FREEWAVE Recommends: Changing these settings from the factory defaults may help to
eliminate interference from other FreeWave networks.
18. Press <Esc> to return to the Main menu.
Shortly after both radios are plugged in they should establish a link with each other and the
connection is complete.
19. Using the Point-to-Point Operation LEDs (on page 107), verify that the radios are operating
as expected.
20. Press <Esc> to exit the Setup menu and resume normal radio operation.
LRS455A-C, LRS455A-CE, LRS455-T
User-Reference Manual
I
I I