Reference Manual
Table Of Contents
- Preface
- 1. Overview
- Untitled
- 2. Equipment
- 3. Installation
- 4. Basic Radio Programming and Setup
- 4.1. Define the Network Type and the Radio's Role in that Network
- 4.2. Establish Communication with Instrumentation and Computers
- 4.3. Establishing Communication with Other Radios in the Network
- 4.4. Set the Data Transmission Characteristics
- 4.5. Set Radio Passwords
- 4.6. Set the Hop Table Size in the Terminal Interface
- 4.7. Set the Radio to a Single Channel in a Terminal Emulator
- 4.8. Set the Radio to Hop Channels
- 4.9. Edit Frequencies for Multiple Channels
- 5. Configure Point-to-MultiPoint Networks
- 5.1. Point to MultiPoint Network Characteristics
- 5.2. Point-to-MultiPoint Network Quick Start (Terminal Interface)
- 5.3. Overlapping MultiPoint Networks
- 5.4. Establishing Communication with Other Radios in a MultiPoint Network
- 5.5. Routing Communication Through the Network
- 5.6. Setting Other MultiPoint Parameters
- 5.7. Reading Diagnostics in Tool Suite
- 6. Configure Point-to-Point Networks
- 7. View Radio Statistics
- 8. Release Notes
- 9. Additional Radio Information
- Appendix A: Technical Specifications
- Appendix B: RF Board Pin-Out
- Appendix C: RS232 Pin Assignments - DB9
- Appendix D: LRS455 Frequency Table
- Appendix E: Factory Default Settings
- Appendix F: Point-to-MultiPoint Operation LEDs
- Appendix G: Point-to-Point Operation LEDs
- Appendix H: FreeWave Legal Information
- Blank Page
- Blank Page
4. Basic Radio Programming and Setup
LUM0020CD Rev June-2020 Page 51 of 112 Copyright © 2019FreeWave
This document is subject to change without notice. This document is the property of FreeWave Technologies, Inc.
and contains proprietary information owned by FreeWave. This document cannot be reproduced in whole or in
part by any means without written permission from FreeWave Technologies, Inc.
4.5. Set Radio Passwords
Use passwords to prevent access to or changing of any of the radio’s parameters. This option is
useful to prevent unauthorized personnel from gaining access to the radio settings.
l If the Setup Port (on page 33) option in the Baud Rate tab is set to (1) Main Only or
(3) Both, the password is only accepted if the option is accessed from the main data
port.
l To use the Password using the diagnostics port, the Setup Port option must be set to (2)
Diagnostics Only.
Warning! If the password feature is enabled and the password is forgotten, the radio must be
returned to FreeWave to have the password disabled.
l Set a Password (on page 51)
l Change the Password (on page 52)
l Disable the Password (on page 52)
4.5.1. Set a Password
1. On the Setup main menu in the terminal interface, select (8) Chg Password to show
this prompt: New PW? (<esc> to exit).
2. To back out of the process and not enable the password press <Esc>.
To set a password, type exactly four characters.
Passwords are case sensitive.
Note: Press <Esc> to cancel the process at any point.
After the four characters are entered, this prompt appears: <Enter> to accept,<esc> to
quit.
3. To accept the password as entered and enable the feature, press <Enter>.
To quit the process and not enable the password, press <Esc>.
Press <Enter> to view the password on the line above.
Important!: The password is case sensitive and every keystroke is a character.
LRS455A-C, LRS455A-CE, LRS455-T
User-Reference Manual
-
1111
••