Reference Manual
Table Of Contents
- Preface
- 1. Overview
- Untitled
- 2. Equipment
- 3. Installation
- 4. Basic Radio Programming and Setup
- 4.1. Define the Network Type and the Radio's Role in that Network
- 4.2. Establish Communication with Instrumentation and Computers
- 4.3. Establishing Communication with Other Radios in the Network
- 4.4. Set the Data Transmission Characteristics
- 4.5. Set Radio Passwords
- 4.6. Set the Hop Table Size in the Terminal Interface
- 4.7. Set the Radio to a Single Channel in a Terminal Emulator
- 4.8. Set the Radio to Hop Channels
- 4.9. Edit Frequencies for Multiple Channels
- 5. Configure Point-to-MultiPoint Networks
- 5.1. Point to MultiPoint Network Characteristics
- 5.2. Point-to-MultiPoint Network Quick Start (Terminal Interface)
- 5.3. Overlapping MultiPoint Networks
- 5.4. Establishing Communication with Other Radios in a MultiPoint Network
- 5.5. Routing Communication Through the Network
- 5.6. Setting Other MultiPoint Parameters
- 5.7. Reading Diagnostics in Tool Suite
- 6. Configure Point-to-Point Networks
- 7. View Radio Statistics
- 8. Release Notes
- 9. Additional Radio Information
- Appendix A: Technical Specifications
- Appendix B: RF Board Pin-Out
- Appendix C: RS232 Pin Assignments - DB9
- Appendix D: LRS455 Frequency Table
- Appendix E: Factory Default Settings
- Appendix F: Point-to-MultiPoint Operation LEDs
- Appendix G: Point-to-Point Operation LEDs
- Appendix H: FreeWave Legal Information
- Blank Page
- Blank Page
4. Basic Radio Programming and Setup
LUM0020CD Rev June-2020 Page 48 of 112 Copyright © 2019FreeWave
This document is subject to change without notice. This document is the property of FreeWave Technologies, Inc.
and contains proprietary information owned by FreeWave. This document cannot be reproduced in whole or in
part by any means without written permission from FreeWave Technologies, Inc.
Slave Security
Setting Description
Description
Slave Security allows Slave radios to accept transmissions from a Master not
included in the Call Book.
l The default setting is 0 - Enabled.
l This allows only a Master listed in the Slave's Call Book to link to that
Slave.
l Set this parameter to 1 to disable Slave Security.
l This allows any Master to call the Slave.
l Slave Security has no effect in Point-to-Multipoint networks where the
Network ID is not set to 255.
l
when the LRS455A-C, LRS455A-CE,
Slave Security must be set to 1
LRS455-T is operating in:
l Mode 6 Slave/Master Switchable.
l a Point-to-Point network where the Slave needs to accept calls from more
than 10 different Masters.
l For more information, see Application Note #5476, Mode 6 (available at
support.freewave.com).
Registration is required to use this website.
l When Slave Security is set to 1, the radio accepts calls from any other
FreeWave radio.
l Additional network security measures can be taken to prevent unauthorized
access (e.g., changing default settings for FreqKey, Hop Table, or
Frequency Zones).
4.4.12. Transmit Power
Transmit Power
Setting Description
Default Setting 10
Options Any number between 0 (zero) and 10
Setup Terminal
Menu
(3) Edit Transmission Characteristics > (5) RF Xmit Power
LRS455A-C, LRS455A-CE, LRS455-T
User-Reference Manual
I
I
I