Reference Manual
Table Of Contents
- Preface
- 1. Overview
- Untitled
- 2. Equipment
- 3. Installation
- 4. Basic Radio Programming and Setup
- 4.1. Define the Network Type and the Radio's Role in that Network
- 4.2. Establish Communication with Instrumentation and Computers
- 4.3. Establishing Communication with Other Radios in the Network
- 4.4. Set the Data Transmission Characteristics
- 4.5. Set Radio Passwords
- 4.6. Set the Hop Table Size in the Terminal Interface
- 4.7. Set the Radio to a Single Channel in a Terminal Emulator
- 4.8. Set the Radio to Hop Channels
- 4.9. Edit Frequencies for Multiple Channels
- 5. Configure Point-to-MultiPoint Networks
- 5.1. Point to MultiPoint Network Characteristics
- 5.2. Point-to-MultiPoint Network Quick Start (Terminal Interface)
- 5.3. Overlapping MultiPoint Networks
- 5.4. Establishing Communication with Other Radios in a MultiPoint Network
- 5.5. Routing Communication Through the Network
- 5.6. Setting Other MultiPoint Parameters
- 5.7. Reading Diagnostics in Tool Suite
- 6. Configure Point-to-Point Networks
- 7. View Radio Statistics
- 8. Release Notes
- 9. Additional Radio Information
- Appendix A: Technical Specifications
- Appendix B: RF Board Pin-Out
- Appendix C: RS232 Pin Assignments - DB9
- Appendix D: LRS455 Frequency Table
- Appendix E: Factory Default Settings
- Appendix F: Point-to-MultiPoint Operation LEDs
- Appendix G: Point-to-Point Operation LEDs
- Appendix H: FreeWave Legal Information
- Blank Page
- Blank Page
Appendix E: Factory Default Settings
FreeWave LRS455A-C, LRS455A-CE, LRS455-T radios ship from the factory with
these default settings:
Operation Mode Default MultiPoint Parameters Default
Point-to-Point Slave 1 (1) MASTER PACKET REPEAT 0
Set Baud Rate Default (2) MAX SLAVE RETRY 9
Baud Rate 19200 (3) RETRY ODDS 0
(A) Data Parity 0 (4) DTR CONNECT 0
(B) Modbus RTU 0 (6) NETWORK ID 255
(C) RS232/485 0 (7) RESERVED -
(D) Setup Port 3 (8) MULTI MASTER SYNC 0
(E) TurnOffDelay/OnDelay 0/0 (9) 1 PPS ENABLE DELAY 255
(F) Flow Control 0 (A) SLAVE/REPEATER 0
Radio Parameters Default
(B) DIAGNOSTICS 0
(1) MAX PACKET SIZE 9 (C) SUBNET ID Disabled
(2) MIN PACKET SIZE 1 Rx ID F
(3) XMT RATE 1 Tx ID F
(4) RF DATA RATE 5 (D) RADIO ID Not Set
(5) RF XMT POWER 10 (E) Local Mode 0
(6) SLAVE SECURITY 0 (F) Radio Name blank
(7) RTS TO CTS 0
(8) RETRY TIMEOUT 255
LUM0020CD Rev June-2020 Page 104 of 112 Copyright © 2019FreeWave
This document is subject to change without notice. This document is the property of FreeWave Technologies, Inc.
and contains proprietary information owned by FreeWave. This document cannot be reproduced in whole or in
part by any means without written permission from FreeWave Technologies, Inc.
LRS455A-C, LRS455A-CE, LRS455-T
User-Reference Manual
I