User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
WavePoint 10e
(ACL) of MAC addresses allows access to the network and adds security against devices that have
not been granted access to the network.
Important: The ACL does NOT secure the data that travels across the network..
Important: If configuring the WavePoint 10e through a wireless connection whose
MAC address is NOT in the ACL, the connection is lost when the changes are
saved.
This does include the laptop used to configure the WavePoint™ device.
Use a wired connection or access from a computer whose address is in the ACL to
access the Configuration pages to make additional updates.
Set the ACL Policy Type
1. Connect to the WavePoint 10e either through an Ethernet cable connected to Ethernet
port 3 or 4 or through the computer's wireless options.
2. Use a web browser to access the Configuration pages.
3. On the Wireless LAN menu, click ACL.
4. Select a Policy Status:
l Open - Allows any wireless device with any MAC address to connect to the
wireless network through the WavePoint 10e.
This is the default.
l Allow - Only permits MAC addresses in the List of MAC Addresses to connect to
the wireless network.
l Deny - Prevents any devices with a MAC addresses in the List of MAC Addresses
to connect to the wireless network.
5. Click Save to save the changes or Cancel to clear any changes without saving.
Add or Edit MAC Addresses in the ACL List
1. Connect to the WavePoint 10e either through an Ethernet cable connected to Ethernet
port 3 or 4 or through the computer's wireless options.
2. Use a web browser to access the Configuration pages.
3. On the Wireless LAN menu, click ACL.
4. Click Add New MAC Address under the List of MAC Addresses table.
LUM0063AA Rev 05/05/2014 Page 93 of 171
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.