User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
WavePoint 10e
1. On the Wireless LAN > Radios > Basic page, set the Access Point.
2. Configure the wireless security settings described in Configuring Wireless
Communication on page 82.
3. On the Wireless LAN > Radios > Basic page, set Repeater 1 and Repeater 2 to
Repeater mode.
4. Configure the wireless security settings to match the AP described in Configuring
Wireless Communication on page 82.
5. Set all components in the network to use the same Channel Width and Channel Size in
the Wireless LAN > Radios > Advanced page described in Defining Advanced Radio
Settings on page 85.
6. Verify the Max Distance parameter for each component is set to twice the distance (2x
Distance) between it and the device to which it connects.
Note: Additional advanced settings not described in this example may be required for the
network.
Example 2: Point-to-Multipoint
In this example:
Note: Repeater 2 must be set to find Repeater 1 for this type of wireless network.
l Data from Host 1 routes directly to the AP.
l Data from Host 2 routes through Repeater 2 and Repeater 1 back to the AP.
Example 2: Point-to-Multipoint
Procedure
Note: All components communicate using a 2.4 GHz radio.
LUM0063AA Rev 05/05/2014 Page 81 of 171
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.