User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
Chapter 4: Configuring Wireless Access
Configuring a Point-to-Point Network
Note: Both components communicate using a 2.4 GHz radio.
1. On the Wireless LAN > Radios > Basic page, set the AP to an Access Point.
2. Configure the wireless security settings described in Configuring Wireless
Communication on page 82.
3. On the Wireless LAN > Radios > Basic page, set the Client to Client mode.
4. Configure the wireless security settings to match the AP described in Configuring
Wireless Communication on page 82.
Point-to-Multipoint Configuration Examples
Multipoint networks can be in any number of configurations. This section provides two examples to
illustrate how to define the wireless settings on the WavePoint 10e Configuration pages.
Example 1: Point-to-Multipoint
In this example:
l Data from Host 1 routes through Repeater 1 back to the Access Point (AP).
l Data from Host 2 routes through Repeater 2 back to the AP.
Example 1: Point-to-Multipoint
Setup Procedure
Note: All components communicate using a 2.4 GHz radio.
Page 80 of 171 LUM0063AA Rev 05/05/2014
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.