User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
WavePoint 10e
Right-click >Edit menu
The Parent Selection Profile Configuration dialog opens.
7. Click the Selection Method list box arrow and select List.
The Parent Selection Profile Configuration dialog refreshes with the MAC ID
Addresses listed in the preferred order.
8. Click the Preferred List list box arrow and select an option:
l Best in List - Select this option to have the WavePoint™ WaveMesh pick the best
parent MAC IDs out of the ones defined in that list.
l This picks the best route out of the list based on the Auto selection defined
under the Auto Schedule Method based on RSSI and hop count.
Best in List is similar to the Auto Scheduled Method except that it
allows exclusion of any parents the WavePoint™ device is not to be
connected to.
Using the Auto Scheduled Method, the device can connect to any
of the parents it sees in the network.
l Follow List Priority - Select this option to have the WavePoint™ WaveMesh
route through the connection list in chronological order (e.g., MAC ID 1 first, then
MAC ID 2, MAC ID 3, etc.)
LUM0063AA Rev 05/05/2014 Page 75 of 171
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.