User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
WavePoint 10e
l DHCP Server - The DHCP server is enabled for the VLAN. It assigns an IP
address within the range specified in the Starting IP Address and Ending IP
Address fields to any network device that requests a DHCP address through the
VLAN.
l Continue with Step 7.
l DHCP Relay - If enabled, devices in the VLAN that request a DHCP address can
also receive IP address leases and corresponding information from a DHCP server
on a different subnet.
l In the Relay Gateway field, enter the IP address of the remote DHCP server.
l When VLAN devices make DHCP requests, the request is passed to the
Relay Gateway IP address.
l Continue with Step 7.
7. If the DHCP Server was selected as the DHCP Setup mode in Step 6, set these
parameters to configure the VLAN-specific DHCP server:
a. In the Starting IP Address field, enter the first inclusive IP addresses the server
can assign an address to.
b. In the Ending IP Address field, enter the last inclusive IP addresses the server
can assign an address to.
Important: These addresses must be in the same IP address subnet
as the router’s VLAN IP address.
c. If available, enter the Primary DNS Server and Secondary DNS Server IP
addresses of the domain name system (DNS) servers, if available on the VLAN.
d. Optional: Enter the Domain Name of the DHCP server.
e. Optional: Enter the WINS Server IP address or the Windows NetBIOS server if the
network has one.
f. Enter the Lease Time, in hours, an IP address is assigned or leased, to a device in
the network.
Set this time as accurately as possible to allow unused IP addresses
to be available for other devices.
8. ClickSave to save the changes and send them to the WavePoint 10e or click the X in the
upper right corner to clear any changes without saving.
LUM0063AA Rev 05/05/2014 Page 61 of 171
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.