User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
Chapter 3: Additional Data Networking Features
Note: After defining a VLAN configuration, only the Inter-VLAN Routing setting
can be changed.
To change the Name or ID, delete the VLAN configuration and add a new
one with the correct parameters.
8. Click Save to save the changes or Cancel to clear any changes without saving.
Delete an Available VLAN
1. On the Network menu, click VLAN > Available VLANs.
The list of defined VLANs is shown.
2. Right-click the VLAN to remove and click Delete.
To delete all VLANs other than the out of the box defaults, right-click
anywhere in the table and click Select All > Delete.
Mapping VLANs to LAN Subnets
l Each configured VLAN ID can map directly to a subnet within the LAN.
l Each LAN port can be assigned a unique IP address.
l A VLAN specific DHCP server can be configured to assign IP address leases to devices
on this VLAN.
Procedure
1. Connect to the WavePoint 10e either through an Ethernet cable connected to Ethernet
port 3 or 4 or through the computer's wireless options.
2. Use a web browser to access the Configuration pages.
3. On the Network menu, click VLAN > Multi-VLAN Subnets.
The available VLAN IDs are shown in the table.
4. Right-click the VLAN ID to configure and click Edit.
5. In the Multi-VLAN Subnet section, complete this subnet information:
a. Enter the IP Address associated with the port assigned with this VLAN ID.
b. Enter the Subnet Mask for the IP address.
6. In the DHCP Setup section, select a VLAN-specific DHCP mode:
l None - The computers on the VLAN are configured with static IP addresses or are
configured to use another DHCP server.
Page 60 of 171 LUM0063AA Rev 05/05/2014
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.