User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
WavePoint 10e
Enabling VLANs
By default, VLANs are disabled in the WavePoint 10e.
VLANs must be enabled before configuring the VLANs through the WavePoint 10e.
Procedure
1. Connect to the WavePoint 10e either through an Ethernet cable connected to Ethernet
port 3 or 4 or through the computer's wireless options.
2. Use a web browser to access the Configuration pages.
3. On the Network menu, click VLANs > Multi-VLANs Subnets.
4. Set the Enable VLAN field to On.
5. Click Save to save the changes or Cancel to clear any changes without saving.
Defining VLANs in the Network
When designing the network and its segmenting areas, define the potential VLANs using the
VLANs > Available VLANs page.
Procedure
1. Connect to the WavePoint 10e either through an Ethernet cable connected to Ethernet
port 3 or 4 or through the computer's wireless options.
2. Use a web browser to access the Configuration pages.
3. On the Network menu, click VLANs > Available VLANs.
The list of currently defined VLANs is shown.
4. Do one of the following:
l Edit an existing VLAN - Right-click an existing VLAN and click Edit.
l Add a VLAN - Below the Available VLANs table, click Add New Available
VLAN.
5. In the Name field, enter a unique identifier used for management purposes.
6. In the ID field, enter a numeric value associated with the VLAN.
This value is used both for management and to update the Ethernet packet header for
member device traffic forwarded through this VLAN.
7. In the Inter-VLAN Routing Enabled field, select On to run traffic between other VLANs
that have this option set to On.
LUM0063AA Rev 05/05/2014 Page 59 of 171
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.