User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
Chapter 3: Additional Data Networking Features
3. On the Network menu, click Routing > RIP.
4. In the IPv4 RIP Configuration section, set the Enabled option to On.
5. In the RIP Version field, select either RIPv1 or RIPv2.
6. Select an Authentication method:
l None - No authentication is used when sending routing table information.
l This is the default setting for both RIP versions.
l It is the only option available if RIPv1 is selected. RIPv1 does not support
authentication.
l Simple - Includes a plain-text key in the transmitted packet.
l The receiving device uses the text key to authenticate the request.
l In the Authentication Key field, enter the plain-text key.
l MD5 - Includes the key in an encoded checksum within the transmitted packet.
l The receiving device uses the key to verify the checksum.
l In the MD5 Key ID field, enter the unique MD5 key ID.
l In the MD5 Authentication Key field, enter the key. The encoding into the
checksum happens after you click Save.
Important: Authentication requires all routers in a RIP network or subnet to
have the same Authentication Type and Key configured.
If the keys do NOT match, the device rejects the packet.
7. Click Save to save the changes or Cancel to clear any changes without saving.
Virtual Local Area Networks (VLANs)
Use WavePoint 10e to isolate areas of the larger network by allocating various traffic to VLANs. A
WavePoint 10e VLAN has similar physical attributes as a LAN, and each VLAN is mapped to a
subnet within the network so that associated traffic passes through a physical port to a VLAN.
By default, VLANs are disabled in the WavePoint 10e. Follow these steps to configure VLANs in
the network:
1. Enabling VLANs on page 59
2. Defining VLANs in the Network on page 59
3. Mapping VLANs to LAN Subnets on page 60
4. Associating Port Traffic to a VLAN on page 62
Page 58 of 171 LUM0063AA Rev 05/05/2014
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.