User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
WavePoint 10e
l Auto-Negotiate l CHAP
l MS-CHAP l MS-CHAPv2
l PAP
9. Select a Reconnect Mode option:
l Always On - Select this option to leave the connection active.
l On Demand - Select this option to automatically end the connection if it is idle for a
specified number of minutes.
l Enter the number of minutes in the Maximum Idle Time field.
This feature is useful if the ISP charges based on the amount of connection
time.
10. In the Server Address field, enter the AAA radius server IP address.
11. In the MPPE Encryption field, enter the AAA radius server encryption information.
12. In the Split Tunnel field, enter the IP address of default gateway on remote network.
13. Click Save to save the changes or Cancel to clear any changes without saving.
Setting the Device Mode
The device mode establishes the routing mode between the LAN and the WAN.
Note: All inbound firewall rules are deleted if the setting between NAT and Router is
changed.
Procedure
1. Connect to the WavePoint 10e either through an Ethernet cable connected to Ethernet
port 3 or 4 or through the computer's wireless options.
2. Use a web browser to access the Configuration pages.
3. On the Network menu, click Network > Device Mode.
4. Select a mode:
l NAT - Network Address Translation (NAT) allows devices on a LAN to share a
single Internet connection.
LUM0063AA Rev 05/05/2014 Page 47 of 171
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.