User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
WavePoint 10e
l Use this MAC - Select this option if the ISP assigned a MAC address to use.
l In the MAC Address field, enter a MAC address in this format:
XX:XX:XX:XX:XX:XX
where X is a number from 0 to 9 or an alphabetical letter between A and F.
8. Click Save to save the changes or Cancel to clear any changes without saving.
Defining WAN Connections Using PPPoE
Select this Internet connection type if the ISP uses Point-to-Point Protocol over Ethernet (PPPoE) to
establish its network connections. If the ISP uses PPPoE to manage its Internet connectivity, a
Username, Password, and additional information are provided. Use this information when defining
the connection type.
Procedure
1. Connect to the WavePoint 10e either through an Ethernet cable connected to Ethernet
port 3 or 4 or through the computer's wireless options.
2. Use a web browser to access the Configuration pages.
3. On the Network menu, click WAN > WAN1 IPv4 Setup or WAN 2 IPv4 Setup.
4. In the Connection Type field, click PPPoE.
5. In the Address Mode field, select an option:
l Dynamic IP - Use if a static IP address has not been assigned.
The ISP automatically assigns an IP address.
l Static IP - Use if the ISP has assigned a fixed (static or permanent) IP address.
l Enter the IP address and the Subnet Mask in the designated fields
6. Enter the Username and Password required to log in to the ISP.
7. Optional: In the Service field, distinguish the two servers using the same Username and
Password combination.
Note: With PPPoE, servers using IP addresses cannot be specified.
However, the particular server to connect to can be specified in the Service
field.
8. Select the Authentication Type to use:
l Auto-Negotiate l CHAP
l MS-CHAP l MS-CHAPv2
LUM0063AA Rev 05/05/2014 Page 45 of 171
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.