User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
Chapter 2: Configuring Basic WavePoint™ Network Features
l In the MAC Address field, enter a MAC address in this format:
XX:XX:XX:XX:XX:XX
where X is a number from 0 to 9 or an alphabetical letter between A and F.
8. Click Save to save the changes or Cancel to clear any changes without saving.
Defining WAN Connections Using DHCP
Using DHCP, the WavePoint 10e can obtain its IP settings automatically from the ISP or DHCP
server.
Procedure
1. Connect to the WavePoint 10e either through an Ethernet cable connected to Ethernet
port 3 or 4 or through the computer's wireless options.
2. Use a web browser to access the Configuration pages.
3. On the Network menu, click WAN > WAN1 IPv4 Setup or WAN 2 IPv4 Setup.
4. In the Connection Type field, click DHCP.
5. In the Dynamic IP (DHCP) section, enter the Host Name to send to the DHCP server.
The host-name string contains only the client's host name prefix.
The server appends the DNS domain name or domain-name options, if any, to derive the
fully qualified domain name.
6. In the Domain Name System (DNS) Servers section, select how to convert Internet
names (e.g., www.freewave.com) to IP addresses to route traffic to the correct resources
on the WAN.
l Get Dynamically from ISP - Select this option if the ISP did not assign a static
DNS IP address.
l Use These DNS Servers - Select this option if the ISP assigned a static DNS IP
address.
l Enter the Primary and Secondary DNS servers in the designated fields.
7. In the MAC Address section, select the method the ISP uses to determine the local
Ethernet address of this WAN port:
l Use Default MAC - Select this option unless the ISP requires MAC authentication
and another MAC address has been previously registered with the ISP.
l Clone your PC's MAC - Select this option to assign the MAC address of the
computer used to configure the WavePoint 10e.
Page 44 of 171 LUM0063AA Rev 05/05/2014
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.