User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
WavePoint 10e
l Connect a CAT 5e Ethernet cable from an 802.3at (PoE+) source to one or both of the
Ethernet PoE Connector ports on the left side of the connector panel.
Note: Depending on the number of radios installed in the WavePoint 10e model,
it may require power through both ports.
Important: Power over Ethernet is only available on some models.
l Connect a power supply to the green Standard Power port on the far right side of the
connector panel. The WavePoint 10e requires power between 10.5Vdc-30Vdc, 24W.
Power Supply Cable
The power supply cable is a 2-wire, size 22AWG.
Screw Torque
For all connections, use these tightening torque minimum and maximum:
l Minimum: 0.22 Nm.
l Maximum: 0.25 Nm.
Network Deployment Scenarios
WavePoint 10e can be installed in a network to provide both wired and wireless access in Point-to-
Point and Point-to-Multipoint scenarios. This extends the Ethernet and real-time communication to
remote parts of the network.
These diagrams illustrate possible network deployment options for a WavePoint 10e using these
symbols:
Access Point
Client
Repeater
Wired Access
This provides a connection to a central office.
LUM0063AA Rev 05/05/2014 Page 31 of 171
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.