User's Manual

Appendix D: Bench Test Verification of WavePoint™ Configuration
10. Click the Mode list box arrow and select ng.
11. Click the Transmit Power list box arrow and select 5.
12. In the Power Constraint text box, enter 5.
13. Click Save to save the changes and close the dialog box.
14. Log out of the WavePoint 10e Configuration window.
15. Repeat Steps 1 to 14 for all WavePoint 10e devices.
16. On the laptop, open either a web browser or a Command prompt.
17. Verify the connection to all WavePoint 10e devices:
l In the web browser, enter 192.168.1.1 (or the designated WavePoint™ IP
address.
l In the Command prompt, use a Ping command.
Successful connection is verified when the WavePoint™ Login window opens when navigating
from a web browser to a WavePoint 10e IP address or successful ping responses are received.
Open Antenna Test Procedure
1. Connect a laptop to the WavePoint 10e using an Ethernet cable connected to Ethernet
port 3 or 4.
2. Connect the appropriate whip stub antenna to each WavePoint™ device.
3. On the Wireless LAN menu, click Radios > Advanced.
The Advanced Radio window opens.
4. In the Radio table, select the radio to change the power settings and right-click.
5. On the right-click menu, select Edit.
The Advanced Radio Configuration dialog box opens.
6. Click the Mode list box arrow and select ng.
7. Click the Transmit Power list box arrow and select 5.
8. In the Power Constraint text box, enter 5.
9. Click Save to save the changes and close the dialog box.
10. Log out of the WavePoint 10e Configuration window.
11. Repeat Steps 1 to 10 for all WavePoint 10e devices.
12. On the laptop, open either a web browser or a Command prompt.
13. Verify the connection to all WavePoint 10e devices:
Page 158 of 171 LUM0063AA Rev 05/05/2014
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.