User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
Chapter B: Installation Instructions
The mounting holes on the bottom panel of each WavePoint 10e provide a variety of ways to mount
the WavePoint 10e using either the mounting flanges or the DIN rail bracket provided in the
mounting kit. Mounting kits provide the hardware necessary to attach the flanges or the DIN rail
bracket to the WavePoint 10e, but do NOT contain items such as a the DIN rail or screws to mount
the flanges to an external surface.
Note: Mounting kits must be purchased separately.
FreeWave Part Number Description
POH0031AA
DIN Rail Mounting Kit
POH0030AA
Wall Mount Bracket Kit (flange)
If mounting outdoors, install the WavePoint 10e in a NEMA-4 rated enclosure. Follow the
installation instructions provided with the NEMA enclosure.
Note: Prior to mounting the WavePoint 10e, write the radio information and the serial
number information on the labels on the back panel. The radio information is helpful
for programming and the Serial Number is required when calling FreeWave
Technical Support for assistance.
LUM0063AARev 05/05/2014 Page 153 of 171
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.