User's Manual

Table Of Contents
Appendix A: Factory Default Settings
These are the factory default settings of the WavePoint 10e device.
l The firewall blocks all outside access.
l The DHCP server on LAN is disabled.
l The WAN port configuration is completed with a DHCP configuration.
l WavePoint 10e is set in Repeater mode.
l The WavePoint 10e has only one active antenna port on Port 1.
l The LAN IP address = 192.168.1.1.
l The User Name = admin.
l The Password = freewave.
LUM0063AARev 05/05/2014 Page 151 of 171
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.