User's Manual

Chapter 6: Management and Administration
Procedure
1. Save the certificate file to a location on a computer or an accessible network location.
2. Connect to the WavePoint 10e either through an Ethernet cable connected to Ethernet
port 3 or 4 or through the computer's wireless options.
3. Use a web browser to access the Configuration pages.
4. On the Administration menu, click Certificates.
The Active Self Certificates table in the middle of the page lists the loaded self
certificates.
5. Click Add New Active Self Certificate below the table.
6. Click Browse to navigate to the certificate file to upload.
7. Select the file and click Open.
8. Click Upload to add the file.
Deleting Certificates
If a certificate expires or is replaced by a newer version, remove the olde certificate from the
WavePoint 10e.
Delete a Single Certificate
1. Connect to the WavePoint 10e either through an Ethernet cable connected to Ethernet
port 3 or 4 or through the computer's wireless options.
2. Use a web browser to access the Configuration pages.
3. On the Administration menu, click Certificates.
The list of loaded certificates is shown.
4. In the certificate table, right-click the certificate to delete and click Delete.
Delete all Certificates
1. Connect to the WavePoint 10e either through an Ethernet cable connected to Ethernet
port 3 or 4 or through the computer's wireless options.
2. Use a web browser to access the Configuration pages.
3. On the Administration menu, click Certificates.
The list of loaded certificates is shown.
4. In the certificate table, right-click any certificate and click Select All > Delete.
Page 142 of 171 LUM0063AA Rev 05/05/2014
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.