User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
WavePoint 10e
Simple Network Management Protocol (SNMP)
This is an Internet-standard protocol for managing devices on IP networks. Devices that typically
support SNMP include routers, switches, servers, workstations, printers, modem racks. It is used
mostly in network management systems to monitor network-attached devices for conditions that
warrant administrative attention.
SNMP is a component of the Internet Protocol Suite as defined by the Internet Engineering Task
Force (IETF). It consists of a set of standards for network management, including an application
layer protocol, a database schema, and a set of data objects.
WavePoint 10e supports SNMP v1, v2c, and v3.
Authentication Certificates
The WavePoint 10e uses digital certificates for authentication between the WavePoint 10e and
Clients over IPsec VPN tunnels.
A digital certificate can be obtained from:
l a well known commercial Certificate Authority (CA) such as Verisign.
l a self certificate request using the options provided in the Certificates page.
Certificates provide authentication of a router's identity and are typically required for most corporate
level VPNs.
Use the Certificates page to:
l View certificates currently loaded and in use in the WavePoint 10e.
l Upload third-party generated certificates.
l Upload self-signed certificates.
l Generate self certificates and the data required to send to a third party CA.
Adding Trusted Certificates (CA Certificates)
A Trusted Certificate is signed by a Certificate Authority (CA) that is different than the identity it
certifies.
A Trusted Certificate certifies that the subject named in the certificate is indeed the owner of the
authentication key. The certificate from an external CA can be upload it to the WavePoint 10e.
Procedure
LUM0063AA Rev 05/05/2014 Page 139 of 171
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.