User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
WavePoint 10e
Important: During a restore operation, do NOT do anything else to the
WavePoint 10e until the operation is complete.
A restoration can take several minutes to complete.
6. After the LEDs are turned off, wait a few more seconds before doing anything with the
WavePoint 10e.
When the restoration process is complete, the WavePoint 10e reboots automatically with the
restored settings.
Restoring Factory Default Settings
At any time, the WavePoint 10e can be restored to the factory default settings listed in Factory
Default Settings on page 151.
Important: When restoring to the factory default settings, the current configuration
settings are erased.
Firewall rules, VPN policies, LAN/WAN settings and all other settings are removed.
The previous settings CANNOT be retrieved unless a backup file was created.
See Back Up Configuration Settings on page 131 to save the current configuration
settings prior to restoring the factory default settings.
Procedure
1. Connect to the WavePoint 10e either through an Ethernet cable connected to Ethernet
port 3 or 4 or through the computer's wireless options.
2. Use a web browser to access the Configuration pages.
3. On the Administration menu, click Maintenance > Backup / Restore.
4. Click Default and OK at the warning message to proceed.
After the factory defaults are installed, the WavePoint 10e reboots automatically with the factory
default settings.
Rebooting
When rebooting the WavePoint 10e, all connections are down during the time it takes to reboot.
Note: The reboot process can take several minutes to complete.
Procedure
1. Connect to the WavePoint 10e either through an Ethernet cable connected to Ethernet
port 3 or 4 or through the computer's wireless options.
LUM0063AA Rev 05/05/2014 Page 133 of 171
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.