User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
WavePoint 10e
3. Locate the WavePoint 10e upgrade file.
4. Save the WavePoint 10e upgrade file to an accessible location on the network or to an
external drive.
5. Connect to the WavePoint 10e either through an Ethernet cable connected to Ethernet
port 3 or 4 or through the computer's wireless options.
6. Use a web browser to access the Configuration pages.
7. On the Administration menu, click Maintenance > Upgrade Via Network.
The Upgrade Via Network window shows this information:
l Name - This is the name assigned to the WavePoint 10e.
l Version - This is the current firmware version.
l Date - This is the date and time the firmware was last updated.
8. Click Browse.
The Choose File to Upload dialog box opens.
9. In the dialog box, search for and select the upgrade file.
10. Click Open.
The Choose File to Upload dialog box closes and the Upgrade Via Network window
is shown.
11. Click Upgrade to start the upgrade.
Important: An upgrade can take several minutes to complete.
Do NOT disconnect power or interrupt the upgrade process in any way until
the upgrade is complete.
Interrupting the upgrade process can render the WavePoint 10e unusable.
After the update is complete, the WavePoint 10e reboots.
12. Refresh the browser session and log in again to access the Configuration pages.
Back Up Configuration Settings
At any time, the Configuration settings on a WavePoint 10e can be saved as a file to the network.
This saved configuration can be:
l loaded to another WavePoint 10e.
l used as a backup to restore a WavePoint 10e to the saved settings.
LUM0063AA Rev 05/05/2014 Page 131 of 171
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.