User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
Chapter 6: Management and Administration
8. Enter the Password and enter it again in the Confirm Password field.
9. Click Save to save the changes or Cancel to clear any changes without saving.
Deleting Users
For security purposes, delete Users that no longer require access to the WavePoint 10e.
Note: The factory default Administrator and Guest users cannot be deleted.
Procedure
1. Connect to the WavePoint 10e either through an Ethernet cable connected to Ethernet
port 3 or 4 or through the computer's wireless options.
2. Use a web browser to access the Configuration pages.
3. On the Administration menu, click Users > Users.
The list of users is shown.
4. Right-click the user to remove and click Delete.
Software Maintenance
When FreeWave releases new software, the WavePoint 10e is updated from the Configuration
pages. These options are also available:
l Load the settings from a saved configuration.
l Reboot using the currently saved configurations.
l Restore to the factory default settings.
l Save the current configuration settings.
Upgrade the WavePoint 10e Software
Use the Configuration pages to upgrade the WavePoint 10e when FreeWave releases new
software (firmware).
Note: The software upgrade is completed through either a direct connection or through a
wireless connection. Update files are located at
www.freewave.com/home/WavePointLogin.
Procedure
1. Open a web browser.
2. Go to the www.freewave.com/home/WavePointLogin page.
Page 130 of 171 LUM0063AA Rev 05/05/2014
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.