User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
WavePoint™ Product Safety
Software Maintenance 130
Upgrade the WavePoint 10e Software 130
Back Up Configuration Settings 131
Restore Configuration Settings 132
Restoring Factory Default Settings 133
Rebooting 133
System Logging 134
Set Up System Event Logging 134
Logging Packet Traffic 135
Log Packet Traffic in an IPv4 Network 136
Sending Log Messages to Email Addresses 136
Sending Logs to Syslog Servers 138
Simple Network Management Protocol (SNMP) 139
Authentication Certificates 139
Adding Trusted Certificates (CA Certificates) 139
Generating Self Certificate Requests 140
Adding Active Self Certificates 141
Deleting Certificates 142
Delete a Single Certificate 142
Delete all Certificates 142
Setting the Date and Time 143
Use an NTP Server to Set the Date and Time 143
Manually Set the Date and Time 144
System Statistics 144
Chapter 7: Diagnostics and Troubleshooting 147
Page 12 of 171 LUM0063AA Rev 05/05/2014
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.