User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
WavePoint 10e
Note: If the Local Identifier Type is NOT an IP address, then negotiation is only
possible in Aggressive mode.
If FQDN, User FQDN, or DER ASN1 DN is selected, the device disables
Main mode and sets the default to Aggressive mode.
36. If applicable, enter the Local Identifier value for the option selected in the Local
Identifier Type.
37. In the Remote Identifier Type field, select an Internet Security Association and Key
Management Protocol (ISAKMP) identifier for the remote device.
Note: If the Remote Identifier Type is NOT an IP address, then negotiation is
only possible in Aggressive mode.
If FQDN, User FQDN, or DER ASN1 DN is selected, the device disables
Main mode and sets the default to Aggressive mode.
38. If applicable, enter the Remote Identifier value for the option selected in the Remote
Identifier Type.
39. Set the Encryption Algorithm option to On to enable Encryption Method.
40. Select one Encryption Method to use to negotiate the Security Association.
Note: Verify the authentication method is configured identically on both sides of
the VPN.
41. Set the Authentication Algorithm option to On to enable Authentication Method.
42. Select one Authentication Method for the VPN header.
Note: Verify the authentication method is configured identically on both sides of
the VPN.
43. Select one Authentication Method:
l Pre-Shared key - Set a password-based key.
l RSA-Signature - Uses the Active Self Certificate uploaded in the Administration
> Certificates page.
44. Enter an alphanumeric Pre-Shared Key to share with the IKE peer.
This field is visible when Pre-Shared Key is selected in the Authentication Method
field.
Important: The key cannot contain double quotes (“).
45. Select one Diffie-Hellman (DH) Group to use when exchanging keys.
The DH Group sets the strength of the algorithm in bits.
LUM0063AA Rev 05/05/2014 Page 115 of 171
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.