User's Manual
Table Of Contents
- WavePoint™ Product Safety
- Preface
- Chapter 1: Introduction
- Key Features and Supported Protocols
- Requirements
- Accessories
- Product Variations
- WavePoint 10e Labels
- WavePoint™ Components
- Certified Antennas
- Connect Power
- Network Deployment Scenarios
- Connecting and Logging In
- Configuration Pages
- Chapter 2: Configuring Basic WavePoint™ Network Features
- Chapter 3: Additional Data Networking Features
- Chapter 4: Configuring Wireless Access
- Example: Point-to-Point Configuration
- Point-to-Multipoint Configuration Examples
- Configuring Wireless Communication
- Defining Advanced Radio Settings
- Verify the Wireless Connection
- Enabling Virtual Access Points
- Wireless Security
- Scheduling When Wireless Connections are Available
- Chapter 5: Security
- Chapter 6: Management and Administration
- Set Up Remote Access to the WAN Port
- User Access Management
- Software Maintenance
- System Logging
- Simple Network Management Protocol (SNMP)
- Authentication Certificates
- Setting the Date and Time
- System Statistics
- Chapter 7: Diagnostics and Troubleshooting
- Appendix A: Factory Default Settings
- Chapter B: Installation Instructions
- Appendix C: WavePoint™ Configurations
- Appendix D: Bench Test Verification of WavePoint™ Configuration
- Appendix E: WavePoint 10e Technical Specifications
- Glossary
- Index
WavePoint 10e
l Time Remaining (sec): The remaining time in seconds the open ports allows external
traffic. This time is reset whenever traffic is sent from the LAN out on the trigger ports.
VPN Tunnels and IPsec
VPNs allow the exchange of data across the Internet through a tunnel including the security and
policies defined in a private network. Using IP Security (IPsec), a dedicated connection with
encryption is enabled across the Internet to the network between:
l Two Gateways
l From a Client to a Gateway
Configuring a VPN Tunnel with IPsec
Use the IPsec Configuration page to define a VPN tunnel for a Gateway connection or for remote
users who access the network with VPN client software.
The IPsec Configuration page simplifies creation of VPN tunnels by setting the VPNC (VPN
Consortium) recommended defaults. The VPN (IKE phase 1 and phase 2) parameters chosen by
the IPsec Configuration are based on the VPN Consortium's (VPNC) recommendations.
Note: More information about the VPNC recommendations can be found at
www.vpnc.org/vpn-standards.
Configuring a Basic VPN Tunnel
1. Connect to the WavePoint 10e either through an Ethernet cable connected to Ethernet
port 3 or 4 or through the computer's wireless options.
2. Use a web browser to access the Configuration pages.
3. On the Security menu, click VPN > IPsec Configuration.
4. Enter a Name for the connection for management purposes.
5. In the Select VPN Type field, select a tunnel type:
l Site-to-Site - Create a Gateway tunnel to another VPN Gateway.
l Remote Access - Create a tunnel to the WavePoint 10e for remote access.
6. Enter the Pre-Shared Key, between 8 and 49 characters, that is shared between devices
for authentication.
Important: This key must be entered exactly the same here and on the
remote VPN Gateway or Client.
LUM0063AA Rev 05/05/2014 Page 109 of 171
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.